TB Electric Moto Tall Comfort Seat

The TB Electric Moto Tall Comfort Seat is a complete ergonomic saddle replacement engineered to eliminate saddle fatigue, open up cramped leg angles, and enhance rider endurance on the Sur-Ron electric dirt bike. Factory seats feature thin, low-density foam that quickly compresses down to the hard plastic seat pan, causing tailbone pain and knee fatigue after 30 minutes of riding.

The TB Electric Moto Comfort Seat adds 25mm (1 full inch) of extra height and incorporates a dual-density foam core: a plush top comfort layer over a high-density, supportive base layer that prevents bottoming out against the pan. Opening the hip-to-peg distance by 25mm reduces knee flexion for adult riders over 5'9", making the transition from seated to standing attack positions effortless.

The seat is wrapped in a durable, textured waterproof gripper skin with high-frequency welded seams that prevent water intrusion during rain, creek crossings, and bike washing.

Direct Bolt-On Assembly: Comes as a complete assembled unit with a rigid injection-molded base pan and pre-installed mounting brackets. Installation takes under 5 minutes by removing the four factory M6 subframe bolts and bolting the new seat in place.

Companion Ergonomic Setup: For total cockpit harmony, combine the Tall Comfort Seat with GritShift 50mm Handlebar Risers and Warp 9 wide billet footpegs.

Frequently Asked Questions:

Q: How much taller is the TB Electric Moto Comfort Seat compared to stock? A: It adds approximately 25mm (1 inch) of additional height, opening up the knee angle for riders over 5'9".

Q: Is this a complete seat assembly or just a foam kit? A: This is a complete, fully assembled seat including base pan, dual-density foam, and waterproof cover, ready to bolt directly onto the bike.

Q: Is the seat cover waterproof? A: Yes. High-frequency welded seams and a waterproof membrane prevent water absorption during rain and bike washes.

Q: What tools are required to swap the seat? A: You only need a 4mm or 5mm hex wrench to remove the four subframe mounting bolts, taking under 5 minutes.

Q: What is dual-density foam? A: Dual-density foam combines a soft top layer for initial plushness with a firmer base layer that prevents the rider from bottoming out against the seat pan.

Long-Range Trail Ergonomics & Seat Height: Saddle discomfort is the number one reason riders cut their trail days short. The TB Electric Moto Tall Comfort Seat solves this problem by combining dual-density foam support with 25mm of extra height, eliminating pressure points on the sit bones and allowing you to explore for hours in complete comfort while reducing knee strain during aggressive standing transitions. The durable gripper cover provides non-slip control in wet conditions.

Waterproof Sealing & Subframe Fasteners: The TB Electric Moto Comfort Seat features high-frequency welded seams and a waterproof membrane beneath the textured gripper skin, preventing water ingress from rain and pressure washing. When reinstalling the seat, torque the four M6 subframe bolts to 10–12 Nm using blue threadlocker.

Dual-Density Foam Core & Subframe Compatibility: The dual-density foam core features a soft 15mm top layer over a high-resilience base layer that prevents bottoming out against the pan, bolting directly to the subframe in under 5 minutes with factory mounting hardware.